Lincoln-electric POWER ARC 5000 Uživatelský manuál stáhnout pdf (Strana 10)

A-3

INSTALLATION

POWER ARC 5000

A-3

STACKING

POWER ARC 5000 machines CANNOT be stacked.

TILTING

Place the machine on a secure, level surface whenev-

er you use it or store it. Any surfaces you place it on

other than the ground must be firm, non-skid, and

structurally sound.

The gasoline engine is designed to run in a level posi-

tion for best performance. It can operate at an angle,

but this should never be more than 15 degrees in any

direction. If you do operate it at a slight angle, be

sure to check the oil regularly and keep the oil level

full. Also, fuel capacity will be a little less at an angle.

LIFTING

The POWER ARC 5000 should be lifted by four peo-

ple. (It weighs 208 lbs/94.3 kg.) Its welded tube roll

cage is designed to make lifting easy.

ASSEMBLY OF VIBRATION ISOLATORS

TO BOTTOM OF TUBE FRAME ( If

wheels are not used)

Tools required - 9/16 wrench or socket.

If the supplied wheels are not used, it is important that the

isolators are installed to keep the machine stabilized when

operated on a smooth surface.

Install the four molded rubber vibration isolators to the bot-

tom of the engine and alternator support channels using four

each of the supplied 3/8-16 X .875 hex head screws, lock-

washers, and large plain washers (spacers). The large plain

washers (spacers) must be installed between the isolator

and the underside of the channels. See Figure A-1.

3/8-16 x .875 Hex Head Bolt

Lockwasher

Frame

Large Plain Washer (Spacer)

Rubber Isolator

Figure A-1

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 49 50

Žádné komentáře

Lincoln-electric POWER ARC 5000 Uživatelský manuál Strana 10